Horse 62: NSD, 'Dennis'

Dennis made his first public appearance at the Wings & Wheels 21st anniversary event, North Weald airfield, Essex. Since his completion in June 2007, Dennis has been busy helping fund raise for the Kent Air Ambulance.

He was also at the Kent County Show helping Demelza House raise much needed funds for sick children. Dennis made the Meridian news, with a brief clip of him in action. Dennis now has his very own web site which you can reach by clicking here:

 

Dennis The Dalek.

 

Andy says,
"It’s a GREAT FEELING being a Dalek owner".

Main Photo

How it was done...

pic1
The skirt panels are 5mm ply. The rear panel was fixed first, using a removable 2”x1” batten to support the top of the skirt towards the front. Then the two front most panels were offered into place and fixed with the aid of a second pair of hands. The rest of the panels were then marked out cut and fixed into place one by one.
pi2
Positioning neck rings: Two bits of plywood cut to the height of the assembled rings, with a slot cut half way in the centre so the two parts can be slotted together. The rings were glued and screwed and then pushed down onto the X shape perfectly centralising them. They were then left until the glue dried.
pic3
Here are the completed shoulders and gun boxes. A section of plywood was put across the front of the shoulders, on the inside, to help fix each gun box in position. The ply has a 110mm hole cut in the face to allow the ball joints to operate freely (when the final holes are cut). The ply makes the section is rock solid.
pic4
The slats were made from 18mm MDF with a piece of 12mm glued centrally, at an angle. This was then run through a bench saw to become 15mm thick. Then two bits of 12mm MDF were glued to the back of each slat to fill the recess. A 16mm flat wood bit was used to create the countersink for the 6mm coach bolts.
pic5
The fender is seen here with temporary aluminium angles fitted. They were used to support the centre join, keeping the fender level. They were removed once the PU adhesive had cured. The steel chassis (yet to be constructed), for the wheel chair mechanism fully supports the fender and the weight of the whole Dalek.
pic6
Here we see the fender mounted on the custom made chassis. The chassis was constructed from scrounged steel off cuts.
After initial construction, the back end needed raising about another 10mm or so as it was grounding during testing, around the workshop!


Forum members click here to read more